三菱 三菱-IB(NA)-0800360E
所屬類別：三菱
>> AJ系列CC-Link模塊
資料介紹：
4. Handling Precautions
(1) Do not drop the module or subject it to heavy impact.
(2) Do not remove the PCB of the module from its case.
Doing so may cause the module to fail.
(3) Prevent foreign matter such as dust or wire chips from entering the
module.
Such foreign matter can cause a fire, failure, or malfunction.
(4) A protective film is attached to the top of the module to prevent foreign
matter, such as wire chips, from entering the module during wiring.
Do not remove the film during wiring.
Remove it for heat dissipation before system operation.
(5) Before handling the module, touch a grounded metal object to
discharge the static electricity from the human body.
Failure to do so may cause the module to fail or malfunction.
(6) Tighten the terminal screws using torque within the following ranges.
Loose screws may cause short circuits, mechanical failures or
malfunctions.
(7) To mount the module on the base unit, fully insert the module fixing
latch into the fixing hole in the base unit and press the module using the
hole as a fulcrum.
Improper installation may result in a module malfunction, or may cause
the module to fall off.
Screw location Tightening torque range
Module fixing screw (M3 screw) 0.36 to 0.48 N•m
FG terminal screw (M3 screw) 0.42 to 0.58 N•m
電流輸入模擬量模塊 Q68ADI
模塊 A1SD35ID1
模塊 AJ35PP-CNV-SI
模擬量輸入模塊 Q68ADV，Q68ADI
模塊 AJ71ID2-R4
適配器 Q6DIN2
模擬量模塊 AJ65VBTCU-68ADIN
模塊 AJ71ID1-R4
模塊 A1SD35ID2
中斷模塊 AI61
模擬輸出模塊 A616DAI
轉(zhuǎn)換電纜 FX2N-CNV-IF
模擬量輸出模塊 Q68DAV，Q68DAI
中斷輸入模塊 QI60
模塊 A1SD32ID2
中繼模塊 AJ65BT-RPI-10B
外部輸入/輸出單元 GT15-DIOR
模塊 AJ35PTC-CNV-GI
ID接口模塊 QD35ID1
模塊 AD32ID1
CCLink模塊 AJ65BT-64DAI
適配器 Q6DIN1
模塊 AJ35PTC-CNV-GI
模塊 AJ35PTC-CNV-SI
外部輸入/輸出單元 GT15-DIO
模塊 A1SJ71ID1-R4
模塊 AD32ID2
模塊 AJ35PP-CNV-GI
模擬量輸出模塊 A616DAI
適配器 Q6DIN1A
上一條：
下一條：相關(guān)下載
